¶ Security Keypads
This document contains information in on the features and operation of third-party keypads compatible with Hubitat Elevation. Please note, more keypads than what is listed here might be compatible. Please check the list of compatible devices and search for “keypad” to find additional compatible devices.
¶ Iris 3405-L (V2)
¶ Features
- One button Arm Away (On), driver option "Verify PIN on arm away" requires valid PIN to arm.
- One button Arm Home (Partial), driver option "Verify PIN on arm home" requires valid PIN to arm.
- Panic
- Motion Sensor
¶ HE Driver
- Iris V2 Keypad
¶ Operation
- Arm Away, On, or PIN code + On
- Arm Home, Partial, or PIN code + Partial
- Disarm, PIN code + Off
¶ Iris iL02_1 (V3)
¶ Features
- One button Arm Away (On)
- One button Arm Home (Partial)
- Panic
- Motion Sensor
¶ HE Driver
- Iris V3 Keypad
¶ Operation
- Arm Away, On
- Arm Home, Partial
- Disarm, PIN code + Off
¶ CentraLite 3400-G
¶ Features
- 3 arming modes (left to right), Arm Home, Arm Away and Arm Night
- Motion Sensor
¶ HE Driver
- CentraLite Keypad
¶ Operation
- Arm Home, PIN code + Arm Home
- Arm Away, PIN code + Arm Away
- Arm Night, PIN code + Arm Night
- Disarm, PIN code
¶ CentraLite 3400
¶ Features
- 3 arming modes (left to right), Arm Home, Arm Away and Arm Night
¶ HE Driver
- CentraLite Keypad
¶ Operation
- Arm Home, PIN code + Arm Home
- Arm Away, PIN code + Arm Away
- Arm Night, PIN code + Arm Night
- Disarm, PIN code
¶ General Notes
All PIN codes are 4 numeric characters; no other lengths will be accepted by the driver. PIN codes can be entered via the device detail page or via Lock Code Manager or another app.
- To enter via driver details using the "Set Code" command
- Enter an unused code position
- Enter an unused PIN code
- Enter a common name for this PIN code
- Click "Set Code", the resulting code if accepted will be visible in Current States, lockCodes
- To edit an existing code via driver details using the "Set Code" command
- Enter the code position you wish to edit
- Enter the existing or new PIN
- Enter the existing or new name
- Click "Set Code"; any changes will be applied.
- If you have difficulty with discovering a keypad, perform a factory reset following the steps below:
- Remove all batteries
- While holding the tamper switch down (tamper is under the wall bracket), insert one battery (Iris V2 and CentraLite), or four batteries (Iris V3), release tamper after two seconds.
- Insert remaining batteries if any, then try again to add the device.